u-bolts

[dmxjg35]

where can i get some u-bolts localy, id like to put my re 4.5" packs in this weekend, but i forgot to order u-bolts for my d35 and the stock ones wont work. any one know anywhere i can go to to get them?

[Chris 88 YJ]

Hackensack Spring made mine while I waited. They are in the yellow pages

[ROCKREADYXJ]

I used to get all my U-bolts from hackensack spring when I was in Jersey. What size block are you trying to cram in there? I might have a set new in stock. Measure your stock ones. I think they are only good for 1 inch blocks.If you have measurements I can dig through all the ones I have and find a set for you.

[dmxjg35]

i dont have any blocks, just a brand new set of re 4.5" leaf packs which i think mesure about 2 3/4 in, i have an add-a-leaf in there now, that mesures like 2 1/2 and theres about 2 threads showing on the stock u-bolts so thats not going to cut it for the new packs

[wrangler]

whats so special about these u bolts...cat u get them at any hrdware store like Sears hardware or somthing?

[dmxjg35]

whats so special about these u bolts...cat u get them at any hrdware store like Sears hardware or somthing?

well for one they need to be huge, like 9" i havent seen any that big at any hardware store, and 2 they need to be hardend since they are holding the axel on all the hardware stores i know of only sell grade 2 which are no good

[ROCKREADYXJ]

Ok you need 9 inches from the bottom of the U to the top? I will check for you. Call my shop 845-355-7625 if it is more or less than 9 inches I may not get back on my computer till later.