Very Productive Weekend

[NYWheeler]

I got everything pulled apart on the YJ. All I have is a rolling chassis and a bare tub not bolted down. I have to wait until Monday to actually pull the tub off then I have to pull the axles on Monday or Tuesday. This coming weekend I have to help my buddy do his v-8 swap in his XJ and then I can focus on stretching the well base on my YJ and setting it up for full width axles. And in between all that I still have to lift my XJ a few inches. Looks like I'm going to be busy for a while.

[badzook]

Wow,

Good luck with all of that...

I know how much work it is to go down to the Bare Frame.....ooooieeee.... :roll: :roll:

badzook

[NYWheeler]

Thanks Badzook, I got everything apart. I'm left with just a bare frame next to my garage and a bare tub in my garage. Suprisingly the tub was very lite. It only took 2 people to remove it from the frame and carry it out of the garage. Should start the welding on the frame in about a week or two.

[we3jeepers]

my brother did that......still is doing that the funds got low
here are some pics in some posts
http://bbb.quadratec.com/cgi-bin/ultimatebb.cgi?ubb=get_topic;f=39;t=005754#000000

this one shows the jeep flat
(rolled going down the highway on a trailer @ 75 mph)
http://www.imagestation.com/picture/sraid118/p9715b4d142508b837c5fa7cb8a3a208e/f88b3a07.jpg

some more here also
http://www.ecoyne.com/viewtopic.php?t=3139&highlight=tinknocker+pics

[NYWheeler]

Don't even talk about funds, I have two Jeeps. Plus I was dumb enough to pull mine apart because I wanted to not because I had to. Good luck with your brother's.