ufatbastehd
03-21-2009, 02:55 PM
url=http://www.jeepforum.com/forum/showthread.php?t=735204]http://www.jeepforum.com/forum/attachment.php?attachmentid=68134&stc=1&d=1237661225&crop_zoom=true[/url]
Description
1991 jeep Wrangler 4.0 stick. Runs good drives straight. 4,000
128,000 miles
Dana 30 up front that was re-geared to 4.10 with new ball joints, steering hardware. 20,000 miles ago. New brake pads 2,000 miles ago.
Ford 8.8 rear -new with only 20,000 miles on it
(I bought these from a fellow Jeeper who had them on his rig but hit a tree.
He got the 8.8 new from OK4wd)
Tom Woods SYE and rear drive shaft.
New T case chain
BDs 3.5 lift springs installed on RE 2.5 Ed hardware(Bushings, shackles etc.
New shocks with less than 6000 mi on them
New Exhaust manifold
New cat and O2 sensor
Entire exhaust is new from the engine back
M.O.R.E Torsion rubber motor mounts
Daystar 1 inch Body lift
Custom rear swing away tire carrier bumper with hitch
Custom front seats. passenger is best top, drivers brand is unknown
Locking center counsole
New sony stereo and front water proof speakers, rear Thor speaker pods.
new fuel pump and rebuilt distributor put in less than 6,000 miles ago.
hard Top
soft top with tinted windows-rear passenger window is cracked
spare set of brand new untinted soft top windows
bikinii top- I never used this so I have no idea it has the necessary hardware
New master cyl
PO had a new clutch put in at approx 108,000 miles
5 new 33x12.5 BFG AT KOs less than 3000 miles on them
Crager Soft 8's
Herc'd interior
Hi Lift jack.
Paint job is rough it was a Maaco job the PO had done and I've touched it up here and there with the idea of painting the rig but I never got around to it.
Included are a 94 Bellhousing and master slave combo to use for an external slave conversion. It also had some rocker rot which I cut out and had new sheet metal welded in. The weld areas need to be smoothed out.
http://i50.photobucket.com/albums/f339/ufatbasted/IMG_3259copy.jpg
http://i50.photobucket.com/albums/f339/ufatbasted/IMG_3258.jpg
http://i50.photobucket.com/albums/f339/ufatbasted/IMG_3257.jpg
http://i50.photobucket.com/albums/f339/ufatbasted/IMG_3254.jpg
http://i50.photobucket.com/albums/f339/ufatbasted/IMG_3252.jpg
http://i50.photobucket.com/albums/f339/ufatbasted/IMG_3253.jpg
http://i50.photobucket.com/albums/f339/ufatbasted/IMG_3255.jpg
http://i50.photobucket.com/albums/f339/ufatbasted/IMG_3256.jpg
http://i50.photobucket.com/albums/f339/ufatbasted/IMG_3260.jpg
I also have a bunch of spare parts laying around brake pads,extended fender flares. You get whatever I have.
I also have reciepts for all work preformed since 80,000 miles. I'm only selling as I don't have the time to work on it anymore and rarely drive it. It deserves a better fate than sitting in front of my house untouched week after week.
More
View Original Listing (http://www.jeepforum.com/forum/showthread.php?t=735204)
Description
1991 jeep Wrangler 4.0 stick. Runs good drives straight. 4,000
128,000 miles
Dana 30 up front that was re-geared to 4.10 with new ball joints, steering hardware. 20,000 miles ago. New brake pads 2,000 miles ago.
Ford 8.8 rear -new with only 20,000 miles on it
(I bought these from a fellow Jeeper who had them on his rig but hit a tree.
He got the 8.8 new from OK4wd)
Tom Woods SYE and rear drive shaft.
New T case chain
BDs 3.5 lift springs installed on RE 2.5 Ed hardware(Bushings, shackles etc.
New shocks with less than 6000 mi on them
New Exhaust manifold
New cat and O2 sensor
Entire exhaust is new from the engine back
M.O.R.E Torsion rubber motor mounts
Daystar 1 inch Body lift
Custom rear swing away tire carrier bumper with hitch
Custom front seats. passenger is best top, drivers brand is unknown
Locking center counsole
New sony stereo and front water proof speakers, rear Thor speaker pods.
new fuel pump and rebuilt distributor put in less than 6,000 miles ago.
hard Top
soft top with tinted windows-rear passenger window is cracked
spare set of brand new untinted soft top windows
bikinii top- I never used this so I have no idea it has the necessary hardware
New master cyl
PO had a new clutch put in at approx 108,000 miles
5 new 33x12.5 BFG AT KOs less than 3000 miles on them
Crager Soft 8's
Herc'd interior
Hi Lift jack.
Paint job is rough it was a Maaco job the PO had done and I've touched it up here and there with the idea of painting the rig but I never got around to it.
Included are a 94 Bellhousing and master slave combo to use for an external slave conversion. It also had some rocker rot which I cut out and had new sheet metal welded in. The weld areas need to be smoothed out.
http://i50.photobucket.com/albums/f339/ufatbasted/IMG_3259copy.jpg
http://i50.photobucket.com/albums/f339/ufatbasted/IMG_3258.jpg
http://i50.photobucket.com/albums/f339/ufatbasted/IMG_3257.jpg
http://i50.photobucket.com/albums/f339/ufatbasted/IMG_3254.jpg
http://i50.photobucket.com/albums/f339/ufatbasted/IMG_3252.jpg
http://i50.photobucket.com/albums/f339/ufatbasted/IMG_3253.jpg
http://i50.photobucket.com/albums/f339/ufatbasted/IMG_3255.jpg
http://i50.photobucket.com/albums/f339/ufatbasted/IMG_3256.jpg
http://i50.photobucket.com/albums/f339/ufatbasted/IMG_3260.jpg
I also have a bunch of spare parts laying around brake pads,extended fender flares. You get whatever I have.
I also have reciepts for all work preformed since 80,000 miles. I'm only selling as I don't have the time to work on it anymore and rarely drive it. It deserves a better fate than sitting in front of my house untouched week after week.
More
View Original Listing (http://www.jeepforum.com/forum/showthread.php?t=735204)