PDA

View Full Version : Bushings almost here?!?!?!?!

Freebird01
01-12-2005, 10:59 PM
I just won two ebay auctions for the poly bushings i need to do my spring swap on my zuk...

hopfully ill be going with CJ front springs in the rear and samurai rear springs in the front. If i get them in time it might even be before the 29th run.

All i need now is some adapter plates and to get my locker installed and ill be good to go....figured id try posting again and try and get this forum going!
XEON
01-12-2005, 11:00 PM
Yea forums been alittle slow because well it just is sometimes... but that sounds awesome. If you are looking for some springs I got my procomp 2.5" out and ready to sell to someone. :) Good luck I hope you get that stuff done for the 29th. I also hope I get my shit done too.... :D
sentinal02
01-13-2005, 06:12 PM
Yea forums been alittle slow because well it just is sometimes... but that sounds awesome. If you are looking for some springs I got my procomp 2.5" out and ready to sell to someone. :) Good luck I hope you get that stuff done for the 29th. I also hope I get my shit done too.... :D

won't work. the YJ springs are 2.5" wide and the sami/CJ springs are 2".
Freebird01
01-13-2005, 06:46 PM
YJ's will work...it would just mean i would have to buy new shackles. lots of guys are putting YJ springs on their zuks. I just got these CJ springs for free and seen alot of good things from this swap without all the fab work.
Luvmyzuki
01-25-2005, 11:31 AM
YJ's will work...it would just mean i would have to buy new shackles. lots of guys are putting YJ springs on their zuks. I just got these CJ springs for free and seen alot of good things from this swap without all the fab work.

Jason,
I put the CJ's on Tom's rig and it was a piece of cake using the adapters from Northcoast. I would assume the YJ adapters would be about the same to install. Don't be afraid. The difference in ride and flex is amazing.
Freebird01
01-25-2005, 11:33 AM
i manged to get two sets of the ruf adapters for a good price. i just need to get the hardware now.

and i had a set given to me so now i got three.....hrrmmm...
Luvmyzuki
01-25-2005, 11:38 AM
i manged to get two sets of the ruf adapters for a good price. i just need to get the hardware now.

and i had a set given to me so now i got three.....hrrmmm...

Fab it up Jay. You should be able to handle it.