The GM Jeep

[yunit]

My good buddy Kert Cohoon at DIY4X cut out some brackets for me, that I designed for the Jeep. The little brackets are for the rear XJ spring conversion and they will be welded onto a peice 2x4-1/4" wall tube, which will be welded to the frame, the tube will also act as the bumper. The big brackets are for the front shackle reversal; they will be welded to 2x4-1/4" wall tube and part of the frame, the brackets will move the front axle forward 4".

http://www.yunit.net/gallery/d/2574-1/DSC02090.JPG

How the Jeep sits right now.
http://www.yunit.net/gallery/d/2546-2/DSC02072.JPG

[XEON]

Very nice! How much did it run to get those cut out?

Keep us updated on that YJ!

[yunit]

I make stickers for Kert, so he "cut" me a great deal. I would of made them myself, but I am not wired up for 220 yet, so the plasma cutter sits in the corner of the garage.

[yunit]

Looks like the plans are changing, I was going to run a 4.3, but I need some more grunt, so now I search for a good 350 and it will be fueled by propane.