Any One Got A Pipe Bender And Wannd Bend Some Pipe

[SleepRob89]

ANY ONE GOT A PIPE BENDER AND WANND BEND SOME PIPE for me all i need is 2 pipes to make a bar for my rollbar to go from the middle bar to the bottom mouny in the back bar let me know or if anyone knowes where i can do this let me know thx

[XEON]

I would like to know this too. I have someone that can bend up some minor stuff for me. But thats about all I know.

[SleepRob89]

yea i want to like make a addon to my yj rollbar thats prob what you want lol

[NYWheeler]

try a local steel supplier they should be able to do it for you. if not than try a speed and performance shop or off road shop. Shouldn't cost much at all to bend two pieces of tubeing.

[XEON]

Ahh yes I can do that too. There is a steel place in Dover, 10 minutes away I can get simple little stuff bent up. Make sure you have all the measure ments and angles ready...

[SleepRob89]

screw it i might just buy a pipe bender not one of the realy expensive ones just one that will do the job

but still let me know if you know of someone or you do it your self THX

[lt705]

I kmow two repair shops in wallington that have pipe benders Bobby O's on paterson plank & the other is behind where diamond auto glass used to be

[SleepRob89]

the harware store on the corner near the shell????

[rockdawg]

I have one of the cheap harbor freight type of benders if you would like to borrow it. What size pipe are you bending?

[lt705]

yep thats the one behind 3 sons hardware & Bobby O's is across from hapco on paterson plank, Question are you still interested in the seats?

[lt705]

yep thats the one behind 3 sons hardware & Bobby O's is across from hapco on paterson plank, Question are you still interested in the seats?

[ROCKREADYXJ]

Are you guys talking about bending tubing for a cage? If so you will need to use a mandrel bender. We can bend the tubing and have the tubing in stock if you guys need. Just give me some angles and lengths. Or bring it by I am only 30 min from bergen county.